The installation of the electric shower can be done in just 6 steps. Check and install yours without needing help
After a tiring day, all we want is to get home and take a nice hot shower, right? Now imagine turning on the shower and seeing that it’s not working and needs to be replaced. In such cases, the question arises: how to install a shower?

It is wrong to think that this task is complicated and that it requires the help of a professional. In fact, shower installation is one of the simplest household jobs to do. Just knowing how to identify the wires and what items will be needed for installation.

Do not believe? So, just read this article to the end to learn how to install electric shower head. Come on?

How to install shower: tools:


The first step is to ensure you have the materials you need to install. Using the correct tooling is important to avoid damage to the product. In some cases, improper handling spoils the shower and makes the consumer lose the right to the item’s warranty. Home Cleaning Tips

You will need:

  • Philips key;
  • screwdriver;
  • test key;
  • stairs;
  • thread sealing tape;
  • insulating tape or electrical connector;
  • pliers;
  • drill (in some cases).
  • All these tools are simple, and you probably already have most of them at home, don’t you? So, let’s go through the installation step by step!

How to install electric shower:

Step 1 – Turning off the electrical current:


Before starting the installation, turn off the electricity and water in the house. Open the shower valve so that all accumulated water drains from the plumbing. Check with the test switch that there is no electrical current. Remember to confirm that the house voltage is right for the appliance and make sure the shower ground wire is connected to a grounding system.

Step 2 – Starting the installation:


Seal the shower water inlet thread with the thread seal tape. This is the entrance on the wall, where the shower pipe will be placed.

Step 3 – Pressure reducer:


Water pressure may differ from property to property. Therefore, to avoid damaging the appliance, install the pressure reducer. This is a small object that comes with the shower. It is usually disk-shaped with a small hole. This part is installed in the water inlet of the equipment. For Plumbing Services in Texas Click here

In this way, it reduces the entry of water into the shower, relieving the pressure. Check if there is a need to install it in your home.

Step 4 – Fixing the shower:


Fit the shower head to the water inlet and turn it clockwise to secure it. Be careful not to force the barrel, as it is a fragile piece.

Step 5 – Identifying the wires:


Connect the shower power wires to the mains. This task is simple and you don’t need to understand much about electricity at this point. Each wire must be installed according to its color. Light blue is the neutral wire. Green or yellow is the earth; red, black or brown is the stage. Don’t forget to insulate the wires with electrical tape.

Step 6 – Accessories and testing:


Fit the accessories (shower, holder, etc.). Before testing the product, allow the water to drain for a few seconds. This is important so as not to damage the shower. Once that’s done, you can turn on the electricity and take a hot shower.

See how installing a shower is a simple task? Now that you’ve learned how to do this installation, how about continuing to figure out how to do minor maintenance? Choose your Plumber Here

Water leaks often cause headaches for residents, but these problems are not always complex. How about learning five things about bathroom water leaks? Read the article to understand more about the subject and be able to accomplish these tasks without needing help!

RELATED ARTICLES

Leave a Reply

Your email address will not be published. Required fields are marked *